中空玻璃打胶机不出胶的原因及解决方法：
Reasons and solutions for failure to release glue from insulating glass sealant dispenser:
1、检查气源是否在0.6～0.8Mpa之间；
1. Check whether the air source is between 0.6 and 0.8Mpa;
2、在触摸屏的编辑功能菜单中检查印章是否未使用；
2. Check whether the seal is not used in the edit function menu of the touch screen;

3、检查气动开关是否被挡住；
3. Check whether the pneumatic switch is blocked;
4、检查黑胶气动开关和电磁阀动作是否正常；
4. Check whether the black glue pneumatic switch and solenoid valve operate normally;
5、检查比例泵上的智能压力表是否报警，范围7-35Mpa；
5. Check whether the intelligent pressure gauge on the proportional pump alarms, with the range of 7-35Mpa;
6、检查液压站内是否有压力，若无压力： 1）清洗比例溢流阀 2）检查比例控制器是否通电或松动；
6. Check whether there is pressure in the hydraulic station. If there is no pressure: 1) clean the proportional overflow valve; 2) check whether the proportional controller is energized or loose;
7、清洗时白胶是否可以释放，如果不能，检查313软管和旋转接头是否堵塞；
7. Whether the white glue can be released during cleaning, if not, check whether the 313 hose and rotary joint are blocked;
8、检查一组比例泵下限传感器IB233是否有信号，检查第二组比例泵IB407是否有信号；
8. Check whether there is a signal from the lower limit sensor IB233 of one group of proportional pumps and whether there is a signal from the second group of proportional pumps IB407;
9、手动检查中空玻璃打胶机的扫描数值是否正常。
9. Manually check whether the scanning value of the insulating glass sealant applicator is normal.
以上就是为大家介绍的有关中空玻璃加工设备详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://freexvideosnow.com
The above is a detailed introduction to the insulating glass processing equipment, and we hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude http://freexvideosnow.com